All best sellers
view_list

Wishlist Products

(0) product

There is no products in wishlist.
Ignition cable set - blue, Ford logo (390-428)
  • Ignition cable set - blue, Ford logo (390-428)
  • Ignition cable set - blue, Ford logo (390-428)

Ignition wires 8mm/ 390-428, blue 64 and 67-73

C7OZ-12259-BL8

64 and 67-73 Ignition cables 8mm (390-428) blue, Ford

.

zł387.00
Tax included
Quantity
Out-of-Stock

favorite_border favorite
Product Details
C7OZ-12259-BL8
0842110187970
842110187970
C7OZ-12259-BL8

Data sheet

Year
1964
1967
1968
1969
1970
1971
1972
1973
64 other products in the same category:

Reference: S1MS-9601-A

Oval air filter 64-73

favorite_border favorite
65-73 Oval air filter, cartridge for Cobra, Shelby, Ford Racing etc... .
zł159.00
More Oval air filter 64-73
In stock

Reference: 83-S

351W oil pump teat

favorite_border favorite
64-73 Oil sump oil suction for oil pump. Designed for standard oil supply system, oil intake from the front of the car. Standard suspension without modification
zł222.00
More 351W oil pump teat
In stock

Reference: C3AZ-9441-A AMS4850

Intake manifold gaskets 302 351W, 64-73

favorite_border favorite
64-73 Gasket under intake manifold, Small Block set. Includes cork gasket for the 302 narrow manifold and for the 351W. Larger outer water passages suitable for 351W and newer 302 heads.Recommended to be licked with sealant. Original 289 heads require gaskets with a smaller water channel. Also available from us.
zł124.00
More Intake manifold gaskets 302 351W, 64-73
In stock

Reference: PCE279.1010

Head Studs 289 302 V8 64-73

favorite_border favorite
64-73 Head Studs for Small Block Windsor engines. Designed for Edelbrock, AFR, and GT40 aluminum heads, but will also work with standard cast iron heads.
zł349.00
More Head Studs 289 302 V8 64-73
In stock

Reference: JV611 40509

One-piece crankshaft seal 351W

favorite_border favorite
Solution to the incessant oil leakage from the rear bed of Small Block 351W engines. It is possible to replace the two-piece shaft seal with a one-piece seal. Block machining is required. It is best when doing an engine overhaul to prepare the rear bed for this Siemerring right away. .
zł95.00
More One-piece crankshaft seal 351W
In stock

Reference: c615

Oil ignition coil 40000 V, 3-Ohm

favorite_border favorite
A 40000 volt, 3Ω oil-filled ignition coil designed primarily for 6-cylinder cars (can operate in V8 up to 5k rpm). Requires the factory resistance wire that every Mustang is equipped with or an external resistor .
zł261.00
More Oil ignition coil 40000 V, 3-Ohm
In stock

Reference: ARP-154-3603

ARP Ford 351W head bolts.

favorite_border favorite
64-73 Head bolts for Small Block Windsor engines. Fits for standard heads and Edelbrock Performer RPM .
zł678.00
More ARP Ford 351W head bolts.
In stock

Reference: 35-1001 EQ-RLR302KIT

Spider for roller pushers

favorite_border favorite
Kit needed when using the new type camshaft and hydraulic tappets. Only on newer 302 blocks.Even if the block was not adapted and it has a place - a stamping in the middle of the block under the intake manifold - can be drilled, tapped and installed.
zł614.00
More Spider for roller pushers
Out-of-Stock

Follow us on Facebook